Zephyr AK7000AS Manual descargar pdf (Pagina 15)

1. Disconnect single blower wire.

2. Remove support screw from top of hood near

the back. Remove 2 screws holding blower plate

to hood and pull blower towards front of hood to

release from internal bracket.

3. Unscrew (4) screws holding blower to blower

plate and remove blower. Remove metal

damper. Discard single blower plate.

4. Picture of PBD-1100A dual blower kit.

5. Use the blower removed from the single blower

plate and install it into the dual blower plate.

DUAL BLOWER INSTALLATION*

*IMPORTANT: Dual blower and heat lamps may only be used together in 36” and 42” models.

30” models will only accommodate one or the other, not both at the same time.

Installation – PBD-1100A Dual Blower

6. Connect 9 pin male molex connector from blower

to 9 pin female molex connector on dual blower

capacitor box.

1 2 ... 10 11 12 13 14 15 16 17 18 19 20 21 22 23

Sin comentarios

Zephyr AK7000AS Manual Pagina 15