Zephyr GU4/MR11 Guía de instalación descargar pdf (Pagina 8)

15. If supplied dismounted for shipping, assemble the lower

part of the hood with the internal blower housing:

a. Remove the grease filter (See also Care & Use

section - Charcoal filter).

b. Rest the internal blower housing on a flat surface and

thread completely the lower part of the hood onto it.

c. Connect all cables:

d. Fasten the hood to the motor unit using 8 screws from

the bottom.

16. Hang hood with the 2 mounting hooks.

WARNING

Excessive Weight Hazard - Use two or more people to

move and install range hood. Failure to do so can result

in back or other injury.

17. Level the appliance, using a carpenters level across

bottom of hood with leveling screws in mounting hooks.

18. Secure hood with 1 screw on bottom.

19. Connect ducting to transition. Seal with duct tape.

Do not use duct smaller than the transition.

For Ductless - recirculating - installations only:

provide and install a duct to connect hood transition to

deflector (The deflector is available as an extra kit).

1 2 3 4 5 6 7 8 9 10 11 12 13 ... 39 40

Sin comentarios

Zephyr GU4/MR11 Guía de instalación Pagina 8