Zephyr GU4/MR11 Guía de instalación descargar pdf (Pagina 13)

www.zephyronline.com

10. Ducting Version-horizontal discharge ONLY:

Connect ducting to transition for horizontal

discharge, seal with duct tape and fix transition to

the wall with four screws, use the included

adhesive rubber tape to seal with hood once

mounted.

stud

Cut out for

vent system

Vent system

Transition with

gravity damper

.....seal with

duct tape.....

...fix to drywall

with max 4 screws....

Upper fastener

location (Hooks)

Installation

11. Determine position of the conduit and cut a 1-1/4"

(3.2 cm) hole at this location. Position the conduit.

Run wires through hole according the National

Electrical Code or CSA Standards and local codes

and ordinances.

There must be enough power supply cable from the

fused disconnect (or circuit breaker) box to make

the connection in the hood’s Junction box/es.

Use caulking to seal all openings. Further

adjustment do conduit passage may be required

when performing electrical connection.

Do Not turn on power until installation is completed.

12.Remark center line and hood bottom on same

location as before and tape template on wall as in

step 4 above.

13.Mount 2 hooks with wood screws (supplied in

mounting hardware kit) on top locations marked on

template, then remove template.

14. If necessary, two plastic spacer can be fitted on

rear side of the hood on screws passages (lower

fastener locations - snap into place) and fit Rubber

adhesive tape as shown in figure below.

Note: before using, the Rubber adhesive tape

supplied must be cut in 3 equal lenght pieces.

Spacers

Rubber tape

1 2 ... 8 9 10 11 12 13 14 15 16 17 18 ... 23 24

Comentarios a estos manuales

Sin comentarios

Zephyr GU4/MR11 Guía de instalación Pagina 13

Comentarios a estos manuales

Relacionado con productos y manuales para Campanas De Cocina Zephyr GU4/MR11